The full name of MOS in English is MOSFET, where the suffix FET stands for Field Effect Transistor.
Categories：Product knowledge Date：2024-11-07 Hits：492 View »
Stability refers to the degree to which the parameters of an inductor coil change with environmental conditions
Categories：Product knowledge Date：2024-11-07 Hits：387 View »
When using neon glow bulbs, the following precautions should be taken
Categories：Product knowledge Date：2024-11-07 Hits：395 View »
The resistance value of the resistor should be calculated according to the design, and standard resistance series resistors should be preferred
Categories：Product knowledge Date：2024-11-07 Hits：368 View »
1. Sudden increase in power supply voltage. There are many reasons that can cause a sudden increase in the voltage of the power supply, such as quality issues with the power supply or improper use by the user.
Categories：Product knowledge Date：2024-11-07 Hits：443 View »
SMA2Z24A SMA YuFeng Microelectronics, original manufacturer of diodes, high-voltage diodes, surface mount diodes, fast recovery diodes, Schottky diodes, low voltage drop Schottky diodes, field-effect transistors, MOSFETs, MOSFET manufacturers, MOSFET production, fast recovery bridge stack, inverter rectifier bridge, rectifier bridge, ESD electrostatic tube, TSS solid-state discharge tube, TVS diode - YuFeng Microelectronics
Categories：Product Subsitution Date：2024-11-04 Hits：329 View »
The identification of the positive and negative terminals of a surface mount diode is usually done by observing the markings on the diode casing. When the markings on the casing are severely worn, a multimeter with an ohm range can be used for identification.
Categories：Product knowledge Date：2024-10-30 Hits：462 View »
ESD electrostatic diode, also known as ESD protection diode, is a commonly used electrostatic protection device. It is mainly used to protect electronic devices from damage caused by electrostatic discharge
Categories：Product knowledge Date：2024-10-30 Hits：423 View »
Transistors and diodes are common electronic components that play important roles in circuits. A transistor has three pins, namely base, emitter, and collector, while a diode only has two pins, namely positive (anode) and negative (cathode)
Categories：Product knowledge Date：2024-10-30 Hits：369 View »
The most basic form of processing analog signals is amplification. In production practice and scientific experiments, analog signals obtained from sensors are usually very weak and can only be further processed after amplification or given sufficient energy to drive actuators and complete specific tasks
Categories：Product knowledge Date：2024-10-30 Hits：408 View »
